DS1200
DS1200
Slag removal machine
Removing slags with hammer and chisel is time consuming and physically demanding work for which Q-Fin has an automatic solution! Q-Fin introduces the DS1200, a freestanding machine which in no time at all removes slag from cutting parts and prevents contamination in the deburring machine.
The DS1200 has been developed by Q-Fin to easily remove slag from sheet metal up to 1200 mm wide.
Suitable for
- 1Slag removal
Steel cutting can occur when steel is cut, these are accumulations of molten steel on the edges of the product. After various processing methods such as plasma cutting and autogenous cutting, these slag can remain on the products, which gives an undesirable result. These cutting methods are usually used when cutting thicker steel plates. A number of factors influence the formation of slag. Most of them have to do with the material itself. This may concern material temperature, surface properties such as a thick mill skin or rust and material composition. For example, more slags will form with alloys with a lot of carbon.
In practice, snails are often knocked off the product with a hammer. A special approach is needed to remove these slag mechanically and it can be realized with the Q-Fin deburring machines. By installing special slag swatter brushes on the F600 or F1200 with magnet support, you can remove these slag easily and quickly.
“Thanks to the 1200 mm wide slag removal machine followed by an F1200 deburring and rounding machine from Q-Fin Quality Finishing Machines, the necessary parts for mast constructions are of an even higher quality. This will reduce the need to use a grinder after the cutting process, resulting in less inconvenience on the work floor and quicker, evenly rounded parts. Q-Fin Quality Finishing Machines thanks you for the beautiful machines and good service!”
– Paul Joordens
Managing director at VDL Mast Solutions
SPECS
– Conveyor belt speed adjustable: 0.3 – 5 m1/min
– Drive: 0.75 kW motor with frequency control
– Product fixation: magnet (for ferrous parts)
– Material of conveyor belt: EPDM
– Control: via switch box or external machine
– Minimum workpiece dimensions: [LxW] 65×65 mm (L and B ≥ 5 x H)
– Workpiece width: 1200 mm
– Maximum belt load: 100 kg
– Machine connection: 400 V, 16 A, 8 kW
– Dimensions : 2016 x 1750 x 2079 mm (L x W x H)
1,250 KG